Toshiba MMD-UP0721HFP-UL Service Manual page 80

Check codes Displayed on by Central Control Device
Check code
Main Outdoor 7-segment display
remote
Check
Sub-code
controller
code
E03 — —
C05 —
C06 —
C12 —
Differs according to
nature of alarm-causing
trouble
P30
(L20 displayed.)
Location
Description System status
of
detection
Indoor unit Indoor-remote Stop of
controller corresponding
communication unit
trouble
(detected at
indoor end)
Central Central control Continued
control device operation
device transmission
trouble
Central Central control Continued
control device reception operation
device trouble
General- Batch alarm Continued
purpose for general- operation
device purpose
I/F device
control interface
Central Group control Continued
control follower unit operation
device trouble
Duplicated Continued
central control operation
address
- 80 -
Check code detection
Check items (locations)
condition(s)
There is no communication • Check remote controller
from remote controller and network adaptor
(including wireless) or wiring.
network adaptor.
Central control device is • Check for failure in central
unable to transmit signal. control device.
• Check for failure in central
control communication line.
• Check termination
resistance setting.
Central control device is • Check for failure in central
unable to receive signal. control device.
• Check for failure in central
control communication line.
• Check terminator resistor
setting.
• Check power supply for
devices at other end of
central control
communication line.
• Check failure in P.C.
boards of devices at other
end of central control
communication line.
Trouble signal is input to • Check trouble input.
control interface for general-
purpose devices.
Trouble occurs in follower • Check check code of unit
unit under group control. that has generated alarm.
([P30] is displayed on central
control remote controller.)
There is duplication in • Check address settings.
central control addresses.