Error Codes; Power-Up Diagnostic Errors - Fluke Biomedical ESA601 Getting Started Manual

ESA601
Getting Started Manual
18
Patient-Leakage Current or Lead-to-Ground-
Leakage Current
Patient-Auxiliary-Leakage Current or Lead-to-
Lead-Leakage Current
Mains-on-Applied-Parts-Leakage Current or
Lead-Isolation-Leakage Current
VDE: Equivalent-Device-Leakage Current
VDE: Equivalent Patient-Leakage Current
VDE: Differential-Leakage Current
Dual-Lead-Leakage Current
Dual-Lead Voltage
Error Codes
The ESA601 performs self-diagnostic tests during power-
up and startup. If a problem is detected during these
times, an error code will be displayed.
Power-Up Diagnostic Errors
A power-up error is indicated if the ESA601 has the
POWER LED on, POWER FAULT LED on, blank display,
and continuously outputs one of the error codes (listed in
Table 5) to the serial transmit line. If any of the Power-Up
Error Codes occur, contact your local Fluke service center
to arrange repair of the ESA601.
Table 5. Power-Up Diagnostic Error Codes
Code Description
0x01 Instruction Test Error
0x05 RAM Test Error
0x09 Flash-Checksum Error