Front Fender; Dc Power Outlets - Yamaha TENERE 700 Owner's Manual

Front fender

To suit the riding conditions, the front
fender height can be adjusted.
To adjust the front fender height
1. Loosen the bolts on each side of
the front fender.
1. Bolt
2. Move the front fender to the de-
sired height.
3. Tighten the bolts to the speci ed
torque.
Tightening torque:
Front fender bolt:
7.5 N·m (0.75 kgf·m, 5.6 lb·ft)
EAUM4130

DC power outlets

This vehicle is equipped with a 5V USB
jack, a grip warmer connector and a
fog lamp DC connector.
NOTICE
Do not use any single electrical ac-
cessory or combination of accesso-
ries that require more than the
stated capacity at any one time. This
may overload the circuit and cause
the fuse to blow.
1
DC power outlet circuit capacities:
USB jack maximum capacity:
5 V (2 A)
Grip warmer and Fog lamp circuit:
120 W (10 A)
TIP
To prevent battery drain, do not use
accessories with the engine off.
4-29
Instrument and control functions
USB jack
EAUM4520
ECA26810
1. USB jack cap
To use the USB jack:
1. Turn off the device before plug-
ging into/unplugging from the
jack.
2. When the USB jack is not being
used, cover it with the cap.
3. Turn the accessory off.
4. If the USB jack overheats or mal-
functions, the indicator light will go
off. If this occurs, have a Yamaha
dealer check the vehicle.
1
4