Front Fender; Dc Power Outlets - Yamaha Tenere 700 2023 Owner's Manual

Instrument and control functions

Front fender

To suit the riding conditions, the front
fender height can be adjusted.
To adjust the front fender height
1. Loosen the bolts on each side of
the front fender.
4
1. Bolt
2. Move the front fender to the de-
sired height.
3. Tighten the bolts to the specified
torque.
Tightening torque:
Front fender bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
EAUM4130

DC power outlets

This vehicle is equipped with an power
outlet, and auxiliary DC connector, a
grip warmer connector and a fog lamp
DC connector.
NOTICE
Do not use any single electrical ac-
cessory or combination of accesso-
ries that require more than the
stated capacity at any one time. This
may overload the circuit and cause
the fuse to blow.
1
DC power outlet circuit capacities:
Power outlet and DC connector cir-
cuit:
24 W (2 A)
Grip warmer and Fog lamp circuit:
120 W (10 A)
TIP
To prevent battery drain, do not use an
accessory with the engine off.
Power outlet
EAU93980
ECA26810
1. Power outlet cap
A 12-V accessory with the proper con-
nector can be used when the main
switch is on.
To use the power outlet
1. Turn the vehicle power off.
2. Remove the power outlet cap.
3. Turn the accessory off.
4. Insert the accessory plug into the
4-24
1
power outlet.