Installing The Front Fender; Installing The Front Wheel - Yamaha JT1 Series Assembly Manual

8 . Installing the
Front Fender
4
Untie the rope that se-
cures the front fender to
the rear wheel. Remove
the fender and unwrap
the paper that covers it.
FRO NT FE NDER
2 . Remove the two nails
holding the plastic block
that secures the front of
the motorcycle to the
wooden frame.
3 .
Lift the motorcycle from
the wooden frame. This
is a job for two men.
Place a support under
the engine to hold the
motorcycle upright.
4 . Using a 10 mm wrench.
remove the three front
fender mounting bolts
and washers from the
frame..
5 . Position the front fender
on the yoke. Secure it
with the three mounting
bolts and washers.
BUSHING
~ LOCK
AXLE
C.
Installing the
Front Wheel
1. Using a 17 mm wrench.
remove the axle from the
front fork assembly. Dis-
card the plastic block. Re-
move the bushing from
the axle.
6