Yamaha TENERE 700 Owner's Manual page 32

Instrument and control functions
Air temperature "AIR":
The air temperature is displayed from –
9 °C (16 °F) to 50 °C (122 °F) in 1 °C (1
°F) increments. The temperature dis-
played may vary from the actual ambi-
ent temperature.
TIP
4
"---" will be displayed if the detected
temperature is higher or lower than the
display range.
Tripmeters "TRIP 1" / "TRIP 2":
"TRIP 1" and "TRIP 2" show the dis-
tance traveled since they were last set
to zero.
TIP
"TRIP 1" and "TRIP 2" will reset to 0
and begin counting again after 9999.9
has been reached.
Countdown tripmeter "TRIP CD":
Counts down from a set distance. Re-
set the countdown tripmeter and the
rst digit will ash. Rotate the "
wheel switch to adjust the ashing dig-
it, short press the "
to con rm and the next digit will ash.
Repeat this until the third digit is con-
rmed and the tripmeter is set.
When the set mileage has been trav-
elled, "0.0" will ash 10 times and then
remain. If another information display
item is being displayed, the countdown
tripmeter will supersede it,
times, and then return to the previously
displayed item.
TIP
The maximum set value is 900.0 km
(600.0 miles)
Fuel reserve tripmeter "TRIP F":
When the fuel tank reserve level has
been reached, "TRIP F" appears auto-
matically and begins recording dis-
tance traveled from that point.
After refueling and traveling some dis-
tance, "TRIP F" will disappear.
Current fuel consumption "INST FU-
EL":
"
The current fuel consumption display
can be set to "km/L", "L/100km" or
" wheel switch
"MPG" in the menu system. (See page
4-15.)
TIP
If traveling at speeds under 10 km/h, "-
-.-" will be displayed.
Average fuel consumption "AVG FU-
EL":
The average fuel consumption display
ash 10
can be to "km/L", "L/100km" or "MPG"
in the menu system. (See page 4-15.)
TIP
After resetting the average fuel con-
sumption display, "--.-" will be shown
until the vehicle has traveled 1 km.
4-12