Dimplex Optimyst CAS500P-RGB-EU Operating Instructions Manual page 9

Once you have made your adjustments to both the flame height and crackling sound, the appliance will keep these set-
tings even if you power off the appliance by either the on/standby button or by the main switch. The next time you switch
on the appliance, it will start up as normal, wait 45 seconds for the flames to start and then revert to the adjusted settings.
MANUAL & REMOTE CONTROL OPTIONS
Standby
Increase Flame
Decrease Flame
Flame Theme
Volume and
crackle sound
(Manual controls)
Increase Volume
(Remote)
Decrease Volume
(Remote)
Brightness
Timer
Bluetooth
FLAME CONNECT APP
The fireplace is capable of being controlled using the Flame Connect App for mobile devices. This is available to down-
load to your device from Google Play or Apple App stores. Follow the on screen instructions for set-up.
NOTE: The fireplace will not operate using the provided remote control when the app is open on a mobile device.
Press to turn on the unit or to put it into standby mode. There is a brief delay after
pressing this button before the unit turns on.
Note: When the unit is turned on there is a 45 second warm up sequence before
the flame effect starts.
Press repeatedly (or press and hold) to increase flame intensity.
The unit will emit an audible beep when max level reached.
Press repeatedly (or press and hold) to decrease flame intensity.
The unit will emit an audible beep when min level reached.
Press repeatedly to cycle through the different Flame themes below:
1 - Natural Flame
2 - Blue
3 - Violet
4 - Red
5 - Aquamarine
6 - Prism Mode - the flames will cycle through the different colours.
Press repeatedly to cycle through volume levels from OFF to level 6.
Press repeatedly (or press and hold) to increase the volume level of the crackling
sound effect.
Press repeatedly (or press and hold) to decrease the volume level of the crackling
sound effect.
Press repeatedly to cycle the Flame brightness settings:
B1 - Brightness level 1
B2 - Brightness level 2
B3 - Brightness level 3
B4 - Brightness level 4
B5 - Brightness level 5
B6 - Pulsating effect
Press repeatedly to set the duration of the timer. The fireplace goes into standby
after the time has elapsed.
The timer can be set for 1 hour (1 presses), 2 hour (2 presses) and Timer OFF (3
presses).
Press this button for pairing remote handset - refer to 'PAIRING THE REMOTE
CONTROL'.
9