Unpacking; Package Contents - Delta 36-6013 Manual

Prior to tool assembly and use, read this manual thoroughly to familiarize yourself with proper assembly, maintenance and safety
procedures.
Check shipping carton and machine for damage before unpacking. Carefully remove components in top foam layer. Remove the top layer
of foam then remove all components in the bottom layer of foam. Lay out all parts on a piece of cardboard or other clean, flat surface. Two
or more people are needed to lift the saw out of the carton. ALWAYS check for and remove protective shipping materials around motors
and moving parts. DO NOT discard shipping carton and packing materials until you have carefully inspected the contents, assembled the
machine and are satisfied that it operates correctly.
Compare package contents to "Package Contents" section and "Hardware Bag Contents" section prior to assembly to make sure all
items are present. Carefully inspect parts to make sure no damage occurred during shipping. If any parts are missing, damaged or pre-
assembled, DO NOT assemble. Instead, call
After assembly remove any protective materials and coatings from all of the parts and the table saw. The protective coatings can be
removed by spraying WD-40
protective coatings are removed completely.

PACKAGE CONTENTS

PC1
PC5
36-6013 Saw Body
PC1
Rip Fence
PC2
10 inch Carbide Tipped Blade
PC3
Miter Gauge
PC4
PC5 Blade Guard Assembly

UNPACKING

DELTA Customer Service at (toll free) 1-800-223-7278.
®
on them and wiping them off with a soft cloth. This may need to be redone several times before all of the
®
PC6
PC11
PC2
PC7
PC12
Anti-Kickback Pawls
PC6
Throat Plate
PC7
Open End Blade Wrench
PC8
Closed End Blade Wrench
PC9
Push Stick
PC10
10
PC3
PC8 PC9
PC13
Stand Part 1
PC11
PC12 Stand Part 2
PC13 Stand Legs (4)
PC4
PC10