Maintenance; Troubleshooting; Accessories - Delta 36-725 T2 Instruction Manual

To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or servicing, before installing and
removing accessories, before adjusting and when making repairs. An accidental start-up can cause injury.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed air. All
plastic parts should be cleaned with a soft damp cloth. NEVER
use solvents to clean plastic parts. They could possibly dissolve or
otherwise damage the material.
LUBRICATION & RUST PROTECTION
Apply hardwood flooring paste wax to the machine table
occasionally or use a commercially available protective product
designed for this purpose. Follow the manufacturer's instructions
for use and safety.
MAINTENANCE REMINDERS
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
Specific areas which require regular maintenance include:
RIVING KNIFE CLAMP PLATE: Keep this area free of dust and
debris buildup. Blow out area regularly with compressed air.
NOTE:
If the riving knife clamp can't move freely, have
the saw serviced by authorized DELTA
Corporation service center personnel.
ADJUSTING BELT TENSION
1.
Lower the blade height to its lowest position.
2.
Loosen the torx screw (A) that is used to mount the
motor housing. This should be loosened enough to feel
the motor weight providing tension to the belt.
3.
Tighten the torx screw (A) to secure the motor in place.
NOTE: If table saw with belt tension adjusted function, only
the technician can do the adjustment.
For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers or call Delta Power
Equipment Customer Care at 1-800-223-7278.
FAILURE TO START
If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the receptacle, and check
reset button on power switch housing. Also, check for blown fuses or open circuit breakers in your power line.
A complete line of accessories is available from your DELTA
Centers. Please visit our Web Site www.DeltaMachinery.com for an online catalog or for the name or your nearest supplier.
Since accessories other than those offered by DELTA
such accessories could be hazardous. For safest operation, only DELTA
should be used with this product.

MAINTENANCE

Wear certified safety equipment for eye, hearing and respiratory
protection while using compressed air.
For best performance use a shop vacuum or blower to keep saw
blade area, the dust collection system, the guarding system and
rails free of saw dust and other debris.
To clean cast iron tables of rust, you will need the following
materials: a medium sized scouring pad, a can of spray lubricant
and a can of degreaser. Apply the spray lubricant and polish the
table surface with the scouring pad. Degrease the table, then
apply the protective product as described above.
WORM GEARS: Keep the worm gears free of dust and debris
buildup. Blow out area regularly with compressed air. Use a
lithium-based multipurpose grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET
PERIODICALLY: NOTE: Debris can also be removed from the
saw from below the throat plate, inside the dust port.
Power Equipment
®

TROUBLESHOOTING

ACCESSORIES

Supplier, DELTA
®
30
A
FIGURE 42
Factory Service Centers, and DELTA
®
have not been tested with this product, use of
®
recommended accessories
®
Authorized Service
®