Adjusting The Bevel Stops - Delta 36-6013 Manual

ADJUSTING THE BEVEL STOPS

Adjusting 0 Degree Positive Stop
If the blade is not vertically square to the table, you MUST adjust
the 0° positive stop, located on the far left end of the bevel track
as shown in Figures 28 and 28a.
1.
Make sure your saw is "OFF" and unplugged.
2.
Secure the bevel lock and raise the blade to its uppermost
position.
3.
Unlock the bevel locking lever and slide the elevation
handwheel to the 0° positive stop position. Lock bevel lock
lever.
4.
Place a combination square next to the blade and check for
90° alignment.
5.
If the blade is not squared 90° to the table, loosen the hex
head screw using the supplied Combination 4mm Allen
A
Wrench/Phillips Screwdriver and adjust the cam until the
blade is square to the table.
6.
Retighten the screw, and check for 90° alignment.
Adjusting 45 Degree Positive Stop
If the blade is not showing an accurate 45° to the table, you MUST
adjust the 45° positive stop, located on the far right end of the
bevel track (maximum 45°) as shown in Figures 29 and 29a.
1.
Make sure your saw is "OFF" and unplugged.
2.
Secure the bevel lock and raise the blade to its uppermost
position.
3.
Unlock the bevel locking lever and slide the elevation
handwheel to the 45° positive stop position.
4.
Place the 45° face of a combination square next to the
blade and check for 45° alignment.
5.
If the blade is not 45° to the table, loosen the hex head
screw using the supplied 4mm Allen Wrench/Phillips
A
Screwdriver and adjust the cam until the blade is at 45
degrees to the table.
6.
Retighten the screw, and check for 45° alignment.
MAKING ADJUSTMENTS
22
0° 0°
28a
A
CAM CAM
FIGURE 28
45°
29a
CAM CAM
A
FIGURE 29
UNLOCK UNLOCK
LOCK LOCK
UNLOCK UNLOCK
LOCK LOCK