On-Board Storage; Making Adjustments; Leveling The Throat Plate - Delta 36-6013 Manual

ON-BOARD STORAGE

Storage is located on the left side and right side of the machine as seen in Figures 19 & 20.
Left Side Storage Figure 19:
Rip Fence
PC2
Push stick
PC10
Miter Gauge
PC4
Right Side Storage Figure 20:
Blade Wrenches
A
Riving Knife (with Blade
B
Wrenches)
Blade Guard Assembly
PC5
Anti-Kickback Pawls
PC6
(Behind Blade Guard Assembly)

LEVELING THE THROAT PLATE

To install throat plate , slip tab into slot at back of saw and push
PC7
down the front of the throat plate to secure in place. See Figure 21.
NOTE: There are four screws pre-assembled to the throat plate
that are used for leveling the throat plate if necessary.
1.
Turn screws clockwise to raise the throat plate, counter
clockwise to lower.
2.
Throat Plate should not be above the table or more than
1/36 inch (0.7mm) below the table on infeed side. On
outfeed side plate should be below the table or no more
than 1/36 inch (0.7mm) above the table.
ASSEMBLY

MAKING ADJUSTMENTS

19
PC4
FIGURE 19
A
PC6
B
FIGURE 20
PC7
Leveling screws Leveling screws
(4) (4)
FIGURE 21
PC10
PC2
PC5