Toshiba RAV-HM301SDTY-E Service Manual page 77

No. Part name
Fan motor, Multi
I
blade fan
Procedure
1. Detachment
1) For the back air intake, perform the procedure
in 1 of "BSuction panel."
2) Perform the procedure in steps 1-1), 1-2), 1-3)
of "DElectric parts box cover."
3) Disconnect the following connector of the
control P.C. board.
NOTE)
Unlock the lock of the housing to disconnect the
connectors.
CN210 ... Fan motor power supply (5P: White)
4) Detach the clamps and binding bands of the
cable.
5) Perform the procedure in steps 1-2), 1-3) of
" Fan case (lower/upper)."
H
6) Remove the screws of the motor bands.
(Ø5×10 2 pcs)
The motor band will not fall off even when the
screws are removed.
7) Hold the motor bands with your hand so that
they do not fall off, and remove the bands.
8) Loosen the hexagonal hole screw of the multi
blade fan and remove the fan from the shaft.
2. Attachment
1) Insert the fan motor shaft into the multi blade
fan, and secure it loosely. With the shaft still
loosely secured, assemble the fan motor, and
secure it using the motor band.
NOTE)
When assembling the fan motor, ensure that the
motors leads are positioned on the left side facing
the drain pan, and assemble the motor so that the
motor leads are pointing straight down.
2) Align the position of the multi blade fan so that
it is positioned at the center of the fan case
(upper) and fix the fan using the hexagonal
hole screw.
– 77 –
Remarks
Clamp
Binding band
Fan motor
Motor band
Motor
leads
Screw
Multi blade fan
Hexagonal hole screw
(Drain pan side)