Table of Contents
Advertisement
Available languages
Available languages
EN
5.2
SPEED BUTTON
Push this button to increase cutting speed according to
grass conditions.
Two green lights on: the machine is in "high speed"
settings.
5.3
START THE MACHINE
Figure 9.
1.
Push the on/off button.
2.
Push the lock-out button and pull the trigger.
5.4
STOP THE MACHINE
Figure 9.
1.
Release the trigger.
2.
Push the on/off button again to turn the machine
off.
5.5
OPERATION TIPS
Figure 10.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
5.6
CUTTING TIPS
Figure 11.
• Tilt the machine towards the area to be cut. Use the
tip of the cutting line to cut grass.
• Move the machine from right to left to prevent
thrown debris toward the operator.
• Do not cut in dangerous areas.
• Do not force the trimmer head into uncut grass.
WARNING
WARNING
English
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood
can wear the cutting line quickly.
5.7
ADJUST THE LENGTH OF THE CUTTING
LINE
Figure 12.
While you operate the machine, the cutting line gets
worn and shorter. You can adjust the length of the
cutting line.
1.
Hit the trimmer head against the ground while you
operate the machine.
2.
Line is automatically released and the cut-off
blade cuts the excess length.
5.8
LINE CUT-OFF BLADE
Figure 13.
This trimmer is equipped with a line cut-off blade
on the guard. The line cut off blade continuously
trims the line to ensure a consistent and efficient cut
diameter. Advance line whenever you hear the engine
running faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep the line long enough to advance properly.
5.9
ADJUST THE CUTTING DIAMETER
Figure 13.
The machine is set at a 35.6 cm cutting diameter.
You can adjust to a 40.6 cm cutting diameter.
Set the cutting diameter to 35.6 cm for greater
runtime and 40.6 cmfor a larger cutting area.
1.
Remove the battery pack.
2.
Remove the blade screws from the cut-off blade.
3.
Turn the cut-off blade 180°.
4.
Tighten the blade screws.
6
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight.
Check regularly that the handles are firmly mounted.
6
NOTE
IMPORTANT
IMPORTANT
Advertisement
Chapters
Table of Contents
