Remove The Battery Pack; Operation; Start The Machine; Stop The Machine - GreenWorks STE457 Operator's Manual

EN
1
8.6

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

1. Push the lock-out switch (4) and pull the trigger (3).
2. Push the speed switch (5) to the desired operating speed.
Push the speed switch to position 1 for low speed or
position 2 for high speed.
9.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
IMPORTANT
WARNING
4
5
English
9.3 ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets worn
shorter. You can adjust the length of the cutting line.
1. While the trimmer is running, bump the trimmer head
against the ground.
2. Line is automatically released and the cut-off blade cuts
the excess length.
9.4 ADJUST THE CUTTING
DIAMETER
The machine is set at a 14 in. (356mm) cutting diameter.
You can adjust to a 16 in. (406mm) cutting diameter.
Set the cutting diameter to 14 in. (356mm) for greater
runtime and 16 in. (406mm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade (11).
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
3
9.5

LINE CUT-OFF BLADE

This trimmer is equipped with a line cut-off blade (11) on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
8
NOTE
11