Operating Instructions; Temperature Units - UEi DT720 Instruction Manual

than 1 second to start or exit "SETUP".The "EXIT" function
is activated in the "RECALL" and "SETUP" mode only.
7. RECALL
Press the "RECALL" button to enter the recall mode.
Press the "HOLD (
and press the "MIN/MAX (
RECALL
SETUP
previous address.
EXIT
In Recall mode, press and hold "MAX/MIN" to step through
the recorded readings of min, max and average. Press the
"HOLD (
MAX/AVG mode of the Recall mode.
Press "RECALL" button to exit Recall mode.
Before Operating
1. Plug the thermocouple(s) into the input terminal(s).
2. Press "
thermometer displays the first reading and its differential
temperature. If no thermocouple is plugged into the selected
input or the thermocouple is "OPEN", the display shows "----".
How to Change Setup Options
Use "SETUP" to reset the thermometer or change the
temperature units, time units, time settings, thermocouple type,
Auto-Power-Off mode, logging interval, and offset.
Entering and Exiting Setup

1. Temperature units.

If you press the "ENTER" button while the "Unit" icon is
blinking, "C" (or F, K) will blink. With "C" (or F, K) blinking,
use the "
button to save the changed value. If you do not want to save the
changed value, press the "EXIT" button.
2. Date If you press "
blinks. Press "ENTER" button while "dAtE" blinks. Then press
" " or "
Year
Press the "ENTER" button while the "YEAr" icon blinks.
Change the year with "
Press the "ENTER" button to save the changed value. If you do
not want to save the changed value, press the "EXIT" button.
)" or "MIN/MAX (

Operating Instructions

" to turn the instrument on. After 1 second, the
", " " buttons to change and press the "ENTER"
" while the "Unit" icon is blinking, "dAtE"
" button to move to "YEAr", " Mon", "dAtE".
)" button to move to the next address
" or " " button while "20YY" is blinking.
7
)" button to move to the
)" button to exit the MIN/