Samsung Max Heat DVM S2 Technical Data Book page 24

Hide thumbs

Table Of Contents

Table of Contents

2. Specification

DVM S2 (460V)

Model Name

Outdoor unit module 1

Outdoor unit module 2

Outdoor unit module 3

Outdoor unit module 4

TransmissionCable

Wiring

Connections

Power supply intake

Type

Refrigerant

Factory Charging

Sound Pressure

Sound

Sound Power

Net Weight

Shipping Weight

Net Dimensions

External

Dimension

(WxHxD)

Shipping Dimensions (WxHxD)

Operating

Cooling

Heating

Temp. Range

NOTE

• Specification may be subject to change without prior notice.

• Specification comply with EN14511.

1) Nominal capacities are based on (Equivalent refrigerant piping : 25ft, Level differences : 0ft);

- Cooling : Indoor temperature 80℉ DB, 67℉ WB / Outdoor temperature 95℉ DB, 75℉ WB

- Heating : Indoor temperature 70℉ DB, 60℉ WB / Outdoor temperature 47℉ DB, 43℉ WB

2) The standard allowed combination ratio of the total rated indoor unit capacity over the rated outdoor unit capacity is 50~130%. Combination ratio of up to

184% is allowed depending on operation mode, minimum operation ratio and connected indoor unit models. DVM Pro 2 design software supports

designing over 130% based on system design. Refer to the "Design Procedure & Combination Ratio" section of this document for details

3) IIf outdoor unit is located in a higher position than indoor unit, level difference is 361ft or under.

(If the level difference is higher than 164ft, the PDM kit should be installed)

*PDM kit: Pressure Drop Modulation kit

4) These products contain R410A which is fluorinated greenhouse gas.

5) Sound pressure was acquired in a dead room. Thus actual noise level may be different depending on the installation conditions.

6) Sound power level is an absolute value that a sound source generates.

Sound pressure level is a relative value, depending on the distance and acoustic environment.

Sound values are obtained in an anechoic room.

Sound values of multi comvination are theoretical values based on sound results of individual installed units.

7) Cooling operation is possible at -15℃(5℉) or higher if satisfied following conditions.

(If the outdoor temperature below -5℃(23℉), wind(snow) protection duct must be installed on the suction side of the heat exchanger and at least 50%capacity of the

connected indoor units must be operated.) However, if the outdoor unit is installed below the indoor unit, cooling operation is possible only at -5℃(23℉) or higher.

8) External static pressure of the model installed as a combined module follows the external static pressure of each single unit.

• For more information regarding capacity correction, please refer to capacity tables available at www.SamsungHVAC.com/downloads.

AM072BXVTJH/AA

Min.

㎟

Remark

Both indoor and outdoor unit Both indoor and outdoor unit Both indoor and outdoor unit

lbs (kg)

Cooling

dB(A)

Heating

dB(A)