LawnMaster CLMF4819X Operator's Manual page 32

TROUBLESHOOTING
Problem
Mower is hard to push.
Mower vibrates overly
and makes excessive
noise.
Possible Cause
High grass and low
cutting height. Rear of
mower housing and blade
dragging in heavy grass.
The cutting blade is not
assembled securely.
The blade is not balanced.
The motor shaft is bent.
Raise the cutting height.
Tighten the blade bolts.
Sharpen and balance the blade
following instructions in this manual (see
page 27). Or replace the blade.
Stop the mower and remove the
batteries. Have the mower inspected
and repaired by an authorized service
center before restarting.
32
Solution