LawnMaster CLMF4819X Operator's Manual page 18

ASSEMBLY
INSTALLING/REMOVING THE BATTERY PACKS
WARNING
If any parts are broken or missing, do not attempt to install the battery packs to the mower or operate the
mower until the broken or missing parts are replaced. Failure to do so could result in serious injury. Do not
install the batteries and/or the safety key before the product is completely assembled. Ensure the safety key is
not fitted before you install the batteries.
NOTE: Both batteries should be installed into the compartments in order to start the mower.
To install battery packs:
1. Make sure both batteries are fully charged.
2. Lift the plastic battery compartment cover on the top of the mower deck.
3. Align the raised ribs on the mower with the grooves in the battery pack, and then insert the battery
packs into the compartment (Fig. 6).
4. Push the battery packs until you hear a "click".
5. Insert the safety key into the keyholes located within the battery compartment.
6. Close the battery compartment cover.
NOTE: Make sure that the battery packs firmly snap into place and are secured to the mower before starting
operation.
To remove battery packs:
1. Stop the lawn mower. Lift the battery compartment cover and remove the safety key.
2. Press the release button on the battery pack, grasp the battery pack firmly and pull out of the
battery compartment. Remove the second battery in the same way (Fig. 7).
3. Close the battery compartment cover.
Fig. 6 Battery Fig. 7
Compartment
Cover
18
II
I