Table of Contents
Advertisement
Section 2
Installation
In this section:
1.
Read this first!
page
2-2
2.
2-3
1)
Unpack and inspect.
2-3
2)
Reposition jumpers on OPTIMOD-FM Cards.
2-3
Fig. 2-1: Jumper Positions, Card #5
2-4
Fig. 2-2: Jumper Positions, Card #6
2-4
Fig. 2-3: Jumper Positions, Cards #8 and #9
2-5
3)
2-5
4)
Return Registration Card.
2-5
5)
Set 8100A + XT2 System Controls.
2-6
3.
Retrofit Instructions
2-6
1)
Open the OPTIMOD-FM ' s front panel, remove subpanel.
2-6
2)
2-7
3)
Install accessory port in OPTIMOD-FM.
2-8
4)
2-8
Fig. 2-4: Accessory Port #2 Installation
2-9
5)
2-10
Fig. 2-5: Card #6 Rework
2-11
6)
Check, rework OPTIMOD-FM Cards #8 and #9.
2-11
4.
2-12
Fig. 2-6: Studio Chassis Jumper Positions, Card #5
2-13
CAUTION
The installation and servicing instructions in this manual are
for use by qualified personnel only. To avoid electric shock
do not perform any servicing other than that contained in
the Operating Instructions unless you are qualified to do so.
Refer all servicing to qualified service personnel.
(perutsia)
Advertisement
Chapters
Table of Contents
