Technical Data - Scheppach SM200L Translation Of Original Instruction Manual

• Grinding discs must be stored in such a way that
they are not exposed to mechanical damage and
damaging environmental influences.
• Do not use defective or deformed grinding discs.
• Check the setting of the spark protection frequently
and adjust it according to the wear of the grinding
disc. Keep the distance between the spark protec-
tion and the grinding disc as small as possible (not
more than 2 mm).
• Check the setting of the tool support frequently and
adjust it according to the wear of the grinding disc.
Keep the distance between the spark protection and
the grinding disc as small as possible (not more than
2 mm).
• Only use grinding discs whose hole fits exactly on
the shaft of the bench grinder. Do not use grinding
discs with too small a hole.
• Do not overtighten the washer nut.
• Do not grind with a cold grinding disc. Allow the
grinding disc to idle for one minute before starting
work.
• Do not grind on the side surfaces of the grinding
disc. Grind only on the front side.
• Do not apply coolant directly on the grinding disc.
Coolant can affect the bond strength of the grinding
disc, causing it to fail.
• Sparks can be dangerous. Do not sand near flam-
mable gases or liquids.
• Stand to the side of the grinding disc when switching
on the device.
• Only true the grinding disc on the front side. Grind-
ing on the side surfaces can make the grinding disc
too thin for safe use.
• Grinding generates heat. Do not touch the work-
piece until it has cooled down sufficiently.
• Only use grinding discs that are designed for safe
use on the bench grinder. Do not use a grinding disc
whose specified maximum rotational speed is lower
than the speed specification of the device.
24 | GB

6. Technical data

ø Disc
Min. disc Ø
(after wear)
Disc hole Ø
Disc width left/right
Work lamp
Weight
Engine
Rated input
Speed
Subject to technical changes!
Duty cycle:
The duty cycle S2 10 min (short-time duty) states that
the engine may only be continuously loaded with the
rated power (500W) for the time specified on the data
plate (10 min). Otherwise, it would heat up impermis-
sibly. During the pause, the motor cools down again
to its initial temperature.
Noise and vibration
The noise and vibration levels have been determined
in accordance with EN 62841.
Sound pressure level L
Uncertainty K
Sound power level L
Uncertainty K
Wear hearing protection.
Excessive noise can result in a loss of hearing.
Keep the noise level and vibration to a minimum!
• Only use faultless devices.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
www.scheppach.com
LED with battery (2x)
230-240 V~ / 50 Hz
S2 10 min 500W
pA
pA
WA
WA
200 / 200 mm
160 mm
15.88 mm
20 / 20 mm
12 kg
S1 250 W
2980 rpm
79 dB
3 dB
92 dB
3 dB