Curt Manufacturing CHT-56438 Installation Manual

INSTALLATION MANUAL
Level of Difficulty
Easy
Electrical Ratings
Signal circuits 3.0-amps per side
Tail / Running Circuits 6.0-amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
Wiring Location(s)
T5
Wiring Location Guide*
for Trucks (T)
T1 Behind driver side taillight housing
T2 Behind passenger side taillight housing
T3 Behind driver side rear bumper
T4 Behind center of rear bumper fascia
T5 Behind passenger side rear bumper
T1 T2
T3 T4 T5
* Representative vehicle shown
Tools Required
Ratchet Cutting tool
Socket, 10mm Flathead screwdriver
Socket extension --
56438-INS-RA • PAGE 1
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
The battery connection must be fuse-protected, 10-amp max. Exceeding
the product rating can cause loss of warranty, overheating and potential fire.
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Maintenance
Periodic inspection of all wires and connections should be performed
to ensure there is no visible damage or loose connections.
Product Registration and Warranty
CURT Group stands behind our products with industry-leading warranties.
Provide feedback and help us to improve our products by registering your purchase at:
warranty.curtgroup.com/surveys