How To Use Your Robot - Eureka NER E10s Instruction Manual

How to use your robot

Operation
Start/pause/resume
Short Press
Press and
Shut down
hold for 3s
Start / Pause / Resume
Briefly Press " " to start/pause/resume cleaning or use your App to control.
SPOT Cleaning
When the robot vacuum is in standby/pause mode, press "
clean an area of one square meter centered on itself. After spot cleaning, the robot will automatically return to
the charging base to recharge.
Note that starting the spot cleaning mode will automatically stop the current cleaning cycle.
1.0m
Recharge
① When the robot vacuum is in standby mode, press "
② When the robot vacuum is in cleaning process, pressing "
recharging.
Under special circumstances (such as power depletion, robot vacuum jamming, etc.), the robot vacuum may not
be able to recharge automatically. Please manually place the robot vacuum back to the charging base.
1. The robot vacuum will enter sleep mode when it is in standby mode for more than 10 minutes. In sleep mode,
press any key to wake up the robot vacuum.
2. Do not immerse the robot in water. Doing so may damage the equipment, causing short-circuit or current leakage.
1. After cleaning, the robot will return to the charging base and automatically begin self-emptying.
2. Press the recharging button (the recharge interval between two times should be longer than 5 minutes) to trigger
self-emptying.
3.
Select manual self-emptying function on the App. Avoid manual self-emptying frequently.
Indicator Light
White light stays on
White light flashes slowly
White light flashes quickly
Return to the base
1.0m
NOTES
Self-Emptying Function
Status Indicators of Self-Emptying Base
Status
Self-emptying base is in sleep mode.
Self-emptying base is powered on.
Self-emptying is in progress.
The air duct of the dust cup may be clogged.
Please check and empty the dust cup in time.
Button
Start spot cleaning
Enter the network pairing state
/
" to start spot cleaning. The robot will begin to
1.0m
1.0m
" and the robot vacuum will start recharging.
" can stop cleaning, and then press "
13
" can start