Eureka NER E10s Instruction Manual page 11

Remove excess clutter and cables on the floor before cleaning.
Installation of side brushes
Turn the main unit over. Attach the side brush to its color-matched
post and press down until they fit into place.
Filter installation
Robot comes with filter installed. Before use, ensure the filter is securely
in place. If not, remove dustbin from robot, pull up lid of dustbin and make
sure filter is snApped into place. Ensure dustbin lid and bottom latch
are securely closed and place back dustbin onto robot.
When using the mopping function, open the tank lid, fill the water tank
with purified cold water, and securely close the lid.
Please do not add any detergent into the water tank to prevent
potential clog.
Setting up self-emptying base
1. Place the self-emptying base flat against the wall on a level surface.
If there is any charging base for other robot vacuum cleaners in the
room, please put it away before use of our self-emptying base to avoid
mismatching.
Place the self-emptying base in an area covered with wireless network
2.
signal to ensure stable network connection of the robot and proper
function of the App.
Store the excess cables into the slot at the back of the charging base
3. Plug the power plug into a power outlet.
Quick Assembly
11
Water Inlet/Outlet