Chapter 1 PREPARATIONS
Placing Paper and Originals
This section explains how to set paper and originals. Incorrect setting causes image skews or paper jams. Follow the
procedure below.
Placing paper
1
Pull out the tray.
2
Set the side guide to match the paper width.
3
After fanning the paper, place it face up.
20
4
Set the end guide to match the paper size.
5
Push in the tray.
Be careful not to catch your fingers when pushing
the tray back.
This could cause an injury.
Check that the height of the paper does not exceed
the MAX line on the side guides.
• See the following page for supported paper:
& Specifications Guide (PDF) : "Chapter 1:
SPECIFICATIONS OF PAPER"
• Follow the procedure above to place paper in the
Paper Feed Pedestal and the Additional Drawer
Module. For placing paper in the Large Capacity
Feeder, see the following guide:
& Paper Preparation Guide (PDF) : "Chapter 1:
LOADING PAPER" - "Loading Paper in Trays"