Oki ES9466 MFP Quick Start Manual page 56

Chapter 3 MAINTENANCE
Cleaning the main chargers and LED print heads or slit glass
If the inside of the main chargers and the print heads of the LED or slit glass are dirty, the dirt will be
transferred to the copied image. Clean them following the procedure below.
1
Open the front cover.
2
Pull out the cleaner until the mark
appears, and then return it. Repeat this 3
times for each color.
Check that the cleaning knob is fully inserted after cleaning.
56
3
Put your fingers in the waste toner box
front grooves and pull it toward you
while pushing down the top latch, and
then clean the LED print heads.
For instructions on how to clean the LED
print heads, see the following page:
& P.49 "Replacing Waste Toner Box"
(Steps 2 to 6)
& P.49 "Replacing Waste Toner Box"
(Steps 2 to 5)
4
Close the front cover.