Installation - Snom SIP Series User Manual

Installation

SIP Corded 1-line Hotel Telephone -
HD350
SIP Corded 1-line Wi-Fi Enabled Hotel
Telephone - HD350W
Telephone base installation
1. Connect both the ethernet cable and
coiled handset cord to the telephone
base and route them along the wire ducts
accordingly. Install the telephone base as
shown below.
~ ~
2. If you are connecting a power adapter,
make sure it is securely plugged into an
outlet not controlled by a wall switch, and
the ethernet cable is plugged into the
network wall jack.
• NOTE: Power adapter is not required for
Power over Ethernet (PoE).
3. Press on the telephone base. Listen for a
dial tone, and then press
up.
• The dial tone will not be played if the SIP
• The power adapter is sold separately.
• Use only the power adapter described in
Use only the supplied ethernet cables. The
supplied ethernet cables are not designed
for use in any other IT devices. Misusing them
on your other IT devices shall be prohibited.
To order a replacement, contact authorized
service personnel, your seller, or Snom.
Installation option - desktop
position
To mount the telephone base on the base
stand
1. Align the grooves of the base stand with
2. Slide the base stand up to secure it.
To unmount the base stand
Simply slide the base stand down, and lift it
from the telephone base.
again to hang
EN - 8
Note
account used by this telephone cannot be
registered.
"Technical specifications" on page 21.
CAUTIONS
the telephone base.