Basic Installation - Snom 300 Quick Reference Manual

Basic Installation

1.
Using the supplied Ethernet (data) cable, plug one end of the
cable into the Ethernet jack on the wall and the other end into
the Snom 300 port labeled "NET".
2.
Plug power supply into the Snom 300 and then into the
electrical outlet on the wall.
**Important**
Once power and network connections are completed, the phone
will begin to boot up and will display "Checking Config" for
approximately 5 minutes. DO NOT PRESS A KEY OR LIFT THE
HANDSET UNTIL YOU SEE YOUR PHONE NUMBER AND THE
CURRENT TIME DISPLAYED ON THE PHONE'S SCREEN. If, after
10 minutes, the phone has not successfully booted up, unplug the
power then reconnect the power to repeat this process again.
Academic Technology Services