Table of Contents
Advertisement
When
using
your
followed to reduce the risk of fire, electric shock and injury, including the following:
1. This product should be installed by a
qualified technician.
2. This product should only be connected
to the host equipment and never
directly to the network such as Public
Switch Telephone Network (PSTN) or
Plain Old Telephone Services (POTS).
3. Read and understand all instructions.
4. Follow all warnings and instructions
marked on the product.
5. Unplug this product from the wall outlet
before cleaning. Do not use liquid or
aerosol cleaners. Use a damp cloth for
cleaning.
6. Do not use this product near water such
as near a bath tub, wash bowl, kitchen
sink, laundry tub or swimming pool, or
in a wet basement or shower.
7. Do not place this product on an unstable
table, shelf, stand or other unstable
surfaces.
8. Slots and openings in the back or
bottom of the telephone base and
handset are provided for ventilation.
To protect them from overheating,
these openings must not be blocked
by placing the product on a soft surface
such as a bed, sofa or rug. This product
should never be placed near or over a
radiator or heat register. This product
should not be placed in any area where
proper ventilation is not provided.
9. This product should be operated only
from the type of power source indicated
on the marking label. If you are not sure
of the type of power supply on the
premises, consult your dealer or local
power company.
Important safety instructions
telephone
equipment,
basic
safety
precautions
10. Do not allow anything to rest on the
power cord. Do not install this product
where the cord may be walked on.
11. Never push objects of any kind into
this product through the slots in the
telephone base or handset because
they may touch dangerous voltage
points or create a short circuit. Never
spill liquid of any kind on the product.
12. To reduce the risk of electric shock,
do not disassemble this product, but
take it to an authorised service facility.
Opening or removing parts of the
telephone base or handset other than
specified access doors may expose
you to dangerous voltages or other
risks. Incorrect reassembling can cause
electric shock when the product is
subsequently used.
13. Do not overload wall outlets and
extension cords.
14. Unplug this product from the wall outlet
and refer servicing to an authorised
service facility under the following
conditions:
• When the power supply cord or
plug is damaged or frayed.
• If liquid has been spilled onto the
product.
• If the product has been exposed to
rain or water.
• If the product does not operate
normally by following the operating
instructions.
controls that are covered by the
operation
adjustment of other controls may
result in damage and often requires
EN - 2
should
always
Adjust
only
instructions.
Improper
be
those
Advertisement
Table of Contents
