ULTIMATE SPEED USML 3.7 A1 Operation And Safety Notes Translation Of The Original Instructions page 14

charge current, before the actual
charging at the time programmed
in the car. In this case the digital
charging display
indicates that the car is being
charged:
The LED strip
up from left to right and this
indicates that current is flowing
into the car.
The display
ing time , the energy supplied
12
, and the charging capacity
13
Finish the charging process
and disconnect the mobile
charging station
The charging process will stop
„
automatically at the time pro-
grammed in the car. The digital
charging display
the charging process is complete:
The full LED strip
If the charging timer in the car
„
is deactivated, then finish the
charging process in the car.
The charging process will stop.
„
The digital charging display
indicates that the charging
process is complete:
14
GB/IE/NI/CY/MT
already
3
continually lights
2
shows the charg-
3
:
1
indicates that
3
lights up.
2
The full LED strip
On the display
off the charging time
energy supplied
Unplug the plug
„
and put the cover cap
plug
Then unplug the mains plug
„
from the 230 V socket.
Wind up the charging cable
„
without kinks.
Store the mobile charging station
„
. in its packaging and keep it in
15 1
the car in an orderly way.
Finish the charging process at
the mobile charging station
If, during charging, the button
„
is pressed for approx. 5 seconds,
the charging process will stop.
The digital charging display
indicates that the charging
process is complete:
The full LED strip
On the display
off the charging time
energy supplied
3
it again for approx. 5 seconds,
a new charging process can be
lights up.
2
you can read
3
.
13
from the car
9
.
9
lights up.
2
you can read
3
. By pressing
13
and the
12
on the
8
7
6
:
1
4
3
and the
12