Access A Module With Cohesionui - Quantifi Photonics SLED 1000 Series User Manual

7.1 Access a module with CohesionUI
You can access Quantifi Photonics modules via CohesionUI from the chassis controller, or from a controller PC .
To connect with a module, you need the IP address of the chassis the module is installed in.
To obtain the IP address of the chassis:
1. Open the Command Prompt window on the chassis controller.
2. Run the ipconfig command.
3. Note down the IPv4 address that is displayed.
To connect with modules via CohesionUI:
1. On the controller or controller PC, open CohesionUI, for example by double-clicking the desktop icon, or open a supported browser (refer
System requirements).
2. Enter the IP address of the chassis as the URL.
On the controller you can use 127.0.0.1 as the URL instead.
3. CohesionUI will launch in the browser, listing all available Quantifi Photonics modules installed in the chassis (refer
chassis).
Quantifi Photonics | SLED 1000 / 1300 Series PXIe User Manual | Document version 1.08
Display modules in a
22 / 61