Table of Contents
Advertisement
(3) In other case
L
(4) In the case the device remains in the finished state of previous sewing
J
(5) Confirming the thread information
M
(In the case one or two bobbins are loaded in the de-
vice (including the hook) other than the case (2).)
1)
Turn the power to the device.
2)
If a bobbin is loaded in the bobbin setting sec-
tion, take it out.
3)
If any other bobbin still remains in the device
(or in the hook), press
bobbin setting section to feed the bobbin to a
position at which the bobbin can be taken out.
Then, carry out the operation procedure (1) or (2).
(In the case the previous sewing has been normally
finished, and one bobbin is placed in the hook and
the other bobbin is placed in the bobbin setting sec-
tion.)
1)
Turn the power to the device.
J to display the sewing screen.
2)
Press
Once the sewing screen is displayed, sewing
can be started.
In other words, the operation required in the afore-
mentioned state is only to turn ON the power to the
device. Note that the number of stitches is set at the
value that is effective at the end of previous sewing.
So, sewing can be started continuously from the
previous sewing.
Every time you press
2, the content of display of the bobbin thread infor-
mation will be changed over.
The display items differ depending on the setting of
the bobbin thread remaining amount determination.
● In the case of the Manual, "Thread consumption
of the current pattern (m)" to "Remainder (x 10
stitches) until the bobbin changing"
● In the case of the Auto, "Bobbin thread remain-
ing amount (%)" to "Bobbin thread remaining
amount (m)" to" Thread consumption for the
current pattern (m)" to "Remainder (cycles) until
the bobbin changing" to "Remainder (x10 stitch-
es) until the bobbin changing"
– 28 –
L to make the
M on the standard screen
Advertisement
Table of Contents
