Table of Contents
Advertisement
(2) In the case both of the two bobbins have been taken out of the device or one (or both)
of the two bobbins is wound with thread
J
I
K
If one of the bobbins is empty, the device winds thread on the bobbin. After the device completes winding of
the bobbin, it enters the standby state waiting for the moment to change the bobbin.
9)
Press
to return to the standard screen 2. Press
ing screen is displayed, sewing can be started.
Special care should be taken when using a bobbin that has been already wound with
thread, since the preset number of stitches may not be sewn in its entirety (i.e, bobbin
thread may run out during sewing) if the quantity of thread wound on the bobbin is not suf-
ficient.
It is recommended to avoid the use of bobbin which has been used halfway or the bobbin wound with un-
known quantity of thread (or to use such a bobbin after removing the thread wound on it by hand until it
becomes empty) in order to totally prevent the aforementioned problem. If it is necessary to use the bobbin
which has been used halfway, it is necessary to set the number of stitches to a smaller value. The quantity of
thread to be removed from a bobbin is large initially, but it will become more and more adequate if the "auto"
is selected.
H
– 27 –
In this case, the steps of procedure to be taken up to
step 5) are same with those in the case of (1). From
step 6), take the following steps of procedure.
6)
Place the first bobbin in the bobbin setting section.
(Refer to
"3-4. How to set a bobbin" p.9
for the bobbin setting procedure.)
In the case the bobbin placed is:
・ empty bobbin, press
I .
・ already wound with thread, press
then press
The bobbin is placed in the hook.
7)
Subsequently, place the second bobbin in the
bobbin setting section.
8)
As with step 6), in the case the bobbin placed in
the bobbin setting section is:
I in the case of an empty
・ Press
bobbin.
K in the case of a bobbin
・ Press
that has already been wound with thread.
The bobbin is placed in the hook.
J to display the sewing screen. Once the sew-
H , then press
H ,
K .
Advertisement
Table of Contents
