System - Sony STR-DG820 Operating Instructions Manual

Insert two R6 (size-AA) batteries in the
RM-AAP021 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave tile remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix mauganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 90).
Tip
Under normal conditions, the batteries should last
lk_rabout 3 months. When the remote no longer
operates the receiver, replace all the batteries with
new ones.
7: Selectingthe speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
SPEAKERS (OFF/A/B/A+B)
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front
speaker system you want to drive.
To select Light up
The speakers connected to the SP A
SPEAKERS FRONT A terminals
The speakers connected to the SP B
SPEAKERS FRONT B terminals
The speakers connected to both the SPA + B
SPEAKERS FRONT A and B
terminals/parallel connection)
To turn off the speaker output
Press SPEAKERS (OFF/A/B/A+B)
repeatedly until the "SPA", "SP B" and
"SP A+B" indicators on the display do not
light up.
"ALL OFF" appears on the display for a while.
Note
You c:umot switch the front speaker system by
pressing SPEAKERS (OFF/A/B/A+B) when the
he:ldphoues are couuected.
30us