Sony STR-DG820 Operating Instructions Manual page 31

8: Calibrating the
appropriate settings
automatically
(AUTO CALIBRATION)
This receiver is equipped with DCAC (Digital
Cinema Auto Calibration) Technology which
allows you to perform automatic calibration as
follows:
• Check the connection between each speaker
and the receiver, a)
• Adjust the speaker level.
• Measure the distance of each speaker from
your listening position, a)
• Measure the speaker size. a)
• Measure the speaker polarity.
• Measure the frequency characteristics, a)b)
a/The measurement result is not utilized in tile
lk_llowing cases.
ANALOG DIRECT is selected.
bYThemeasurement result is not utilized in tile
l'ollowing cases.
Dolby TrueHD signals with a sampling
frequency of more than 96 kHz are being
received.
PCM signals with a sampling frequency of more
than 96 kHz are being received.
The DCAC is designed to obtain proper sound
balance in your room. However, you can
adjust the speaker levels and balance manually
according to your preference. For details, see
"9: Adjusting the speaker levels and balance
(TEST TONE)" (page 37).
Before you perform the Auto Calibration, set
up and connect the speakers (page 16, 17).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones to this jack.
Doing so may damage the receiver and the
microphone.
• During the calibration, the soundthat comes
out of the speakers is very loud. The volume
of the sound cannot be adjusted. Pay
attention to the presence of children or to the
effect on your neighborhood.
• Perform the Auto Calibration in a quiet
environment to avoid the effect of noise and
get a more accurate measurenlent.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacles from the
measurement area to avoid measurement
error.
Notes
• Tile Auto Calibration function does not work in tile
follewing cases.
SPEAKERS (OFF/A/B/A+B) is set to eft.
Headphones are connected.
• If you activate the muting functien during Auto
Calibration. tile mutieg function will automatically
be set te off.
Optimizer microphone
0
continued_
31 us