True TRM4M-BLK-WHT1-BLKLLLL-NY-4 Owner's Manual page 36

Maintenance & Servicing (cont.)
Reversal
Assistance recommended!
lb (22.7 kg). Do not lift or support the door by the
handle.
Crush or cut hazard!
support the door's weight during removal. Do not lift
or support the door by the handle.
Only the rightmost doors on N sides can be reversed.
See your full model name.
Only freezer doors contain wires.
Required Tools
Required tools include (but may not be limited to) the following:
• Phillips Screwdriver or Bit Driver
• Needle Nose Pliers
• 7/16" Socket wrench
• Putty Knife
• 1/4" Hex Head Driver
• Drill (optional)
Procedure
1. Locate the replacement torque master plate and cover plate
in the interior packaging with the leveling tools. See fig. 10. Set
aside.
2. Remove the door. See "Removal" (pg. 34).
3. Carefully lay the removed door handle-side down.
4. Reverse the door.
a. Remove the wire cover from the door's side. See fig. 11.
b. If applicable, disconnect the hinge pin wires.
See figs. 12 and 13.
c. Remove the hinge pin.
d. Carefully remove the torsion rod.
NOTICE › Removing the torsion rod may require slightly
rotating the rod to get the torsion rod cap to clear the door.
See fig. 14.
Page 36 of 44
WARNING!
Door weight exceeds 50
Doors are heavy. Be prepared to
NOTICE!
RETAIL MERCHANDISER
e. Install the torsion rod in the opposite side
f. Install the hinge pin in the opposite side. If applicable,
connect the hinge pin wires as follows:
•
Hinge pin white
•
Hinge pin red
•
Ground
g. Reinstall the wire cover.
h. Remove the hold-open bracket.
i. Remove the plastic cap. See fig. 15
j. Swap the hold-open bracket and plastic cap locations.
NOTICE ›
facing the door.
k. Move the magnet assembly to the opposite side.
NOTICE ›
5. If applicable, move the hinge pin plug to the opposite side.
See fig. 16.
6. If applicable, move the hinge pin cover to the opposite side.
See fig. 17.
7. Remove the torque master assembly and the existing cover.
See fig. 18.
8. Move the torque master to the replacement torque master
plate. See fig. 19.
9. Install the replacement cover and replacement torque master
assembly on the opposite sides.
NOTICE ›
assembly with the alignment adjustment screw out. See fig. 20.
10. Install the reversed door. See "Installation" (pg. 35).
Fig. 10.
Cover plate and torque master plate. Located in the interior packaging with
the leveling tools.
12/11/2023
to
door white
to
door black
to
door
Hold-open bracket installs with the convex side
Magnet assembly holes are predrilled.
Be sure to install the replacement torque master
P#842860
www.truemfg.com
TEC_TM_180 | REV. D | EN