True TRM4M-BLK-WHT1-BLKLLLL-NY-4 Owner's Manual page 35

Maintenance and Servicing (cont.)
Installation
Assistance recommended!
lb (22.7 kg). Do not lift or support the door by the
handle.
Crush or cut hazard!
support the door's weight during removal. Do not lift
or support the door by the handle.
Required Tools
Required tools include (but may not be limited to) the following:
• Phillips Screwdriver or Bit Driver
• Rubber Mallet (possible)
• Drill (optional)
Procedure
1. Lift the door (by the frame) and set it in the torque master
hole. Be sure the door is fully seated.
NOTICE › Do not lift the door by the handle.
2. Hold the door perpendicular to the appliance.
3. Align the hinge pin (see fig. 8). Then, push the door's top
towards the appliance until the hinge pin clicks into place.
NOTICE › Getting the hinge pin fully seated may require a
rubber mallet.
4. Verify the hinge pin securely holds the door. Pull down on the
door.
5. Install the hold-open bracket onto the appliance. See fig. 9.
6. Add door tension until the door gently self-closes from 2-3"
(50.8-76.2 mm). See "Tension Adjustment" (pg. 33).
7. Verify door alignment. Adjust alignment as needed. See
"Alignment Adjustment" (pg. 33).
TEC_TM_180 | REV. D | EN
WARNING!
Door weight exceeds 50
Doors are heavy. Be prepared to
RETAIL MERCHANDISER
Fig. 8.
Align the hinge pin.
Fig. 9. Hold open bracket screw location at the top of the door.
12/11/2023
www.truemfg.com
Page 35 of 44