Operation; Troubleshooting - fantastic furniture Elevate Assembly Instructions Manual

Step 10

OPERATION:

Height Adjustment (Up)
Left button (Up)
1. Continuously hold the button to raise the table and release when it arrives
at the desired height.
2. The desk will stop automatically when it is raised to the highest position.
Right button
1. Continuously hold the button to lower the table and release when it arrives
at the desired height.
2.The desk will stop automatically when it is lowered to the lowest position.
+ Reset
1. Press and hold the up and down buttons at the same time for 3 seconds
until the desk automatically moves down. At this time you can release the buttons.
You will hear 4 beeps signalling that the Reset operation is complete.

TROUBLESHOOTING

PROBLEM
1-time beep
2-time beep
3-time beep
4-time beep
fantasticfurniture.com.au
N
ROOT CAUSE
Line voltage too low.
Motor temperature is too high
or has been in continuous
operation for more than
2 minutes.
There is too much weight
on the desktop or the motor
is overloaded.
Motor without electricity.
Electric system breakdown.
Controller
Replace power supply adapter.
Rest system for 18 minutes
before continuing to operate.
Decrease desk top max loading
under 45kg. Unplug the power cord
and re-plug after 1 minute,
perform RESET operation.
Check to see if the motor wire is
connected properly.
Unplug the power cord and re-plug
after 1 minute, perform RESET operation.
Unplug the power cord and re-plug
after 1 minute, perform RESET operation.
Height Adjustment (Down)
CORRECTIVE ACTION
Page 14