Fayat Group BOMAG BC 463 RB-3 Service Manual page 30

General – Concerning your safety
1.2.10.3 Working on the engine
1.2.10.4 Maintenance work on electric components and battery
30
Any hydraulic oil must be caught and disposed of in an environ-
mentally friendly manner.
Always catch and dispose of hydraulic oils separately.
Do not start the engine after draining the hydraulic oil. Once all
work is completed (with the system still depressurized!) check all
connections and fittings for leaks.
Hydraulic hoses must be visually inspected at regular intervals.
Do not mix up hoses by mistake.
Only genuine BOMAG replacement hydraulic hoses ensure that
the correct hose type (pressure range) is used at the right location.
Do not work on the fuel system while the engine is running -
danger to life due to high pressures!
Wait until the engine has stopped, then wait approx. another 15
minutes.
Keep out of the danger zone during the initial test run.
In case of leaks return to the workshop immediately.
Drain the engine oil at operating temperature – danger of scalding!
Wipe off spilled oil, collect leaking oil and dispose of it in an envi-
ronmentally friendly way.
Store used filters and other oil contaminated materials in a sepa-
rate, specially marked container and dispose of them in an environ-
mentally friendly way.
The settings for idle speed and highest speed must not be
changed, since this would affect the exhaust gas values and cause
damage to engine and power train.
Engine and exhaust system work at high temperatures. Keep com-
bustible materials away and do not touch any hot surfaces.
Check and change coolant only when the engine is cold. Collect
coolant and dispose of it in an environmentally friendly way.
Before starting to work on electric parts of the machine disconnect
the battery and cover it with insulating material.
Do not use fuses with higher ampere ratings and do not bridge
fuses.
When working on the battery, smoking or open fire is prohibited!
Do not lay any tools or other metal objects on the battery.
Do not wear jewellery (watch, bracelets, etc.) when working on the
battery.
The connection cables of the battery must not touch or rub against
machine parts.
BC 463 RB-3 / BC 473 RB/RS/EB-3