1.3
Identification in clock system
Fig. 10 Identification of nuts in clock system
For small nuts (Fig. 10) the clock system can be used
for identification.
The 12 o'clock position is identified by a dot or the
l
manufacturer's symbol.
The strength class is identified by a dash (b).
l
28
Identification of UNF-threads
Fig. 11
Screws
The screw head is marked with a stamped in, round
cavity 3 (Fig. 11).
Nuts
An uninterrupted series of stamped in circles parallel
to the axis of the nut on a hexagon area (2).
Studs and brake rods
At the outmost end a short end of the component is re-
duced to its core diameter (1).
BOMAG
General repair instructions
008 916 89