Fayat Group BOMAG BW 191/206 AD-5 Service Manual page 18

General – Concerning your safety
1.2.3.2 Regular safety inspections
1.2.3.3 Modifications and alterations to the machine
1.2.3.4 Damage, defects, misuse of safety devices
1.2.3.5 Roll Over Protective Structure (ROPS)
18
Both the machine as well as all other system components comply
with the currently valid safety regulations. Nevertheless, remaining
risks cannot be ruled out completely, even when using the machine
for the purpose it is intended for and following all information given
in the operating instructions.
A remaining risk can also not be excluded beyond the actual
danger zone of the machine. Persons remaining in this area must
pay particular attention to the machine, so that they can react
immediately in case of a possible malfunction, an incident or failure
etc.
All persons remaining in the area of the machine must be informed
about the dangers that arise from the operation of the machine.
Have the machine inspected by an expert / qualified person as
required for the conditions the machine is working under, but at
least once every year.
Unauthorized changes to the machine are prohibited for safety rea-
sons.
Original parts and accessories have been specially designed for
this machine.
We wish to make explicitly clear that we have not tested or
approved any parts or accessories not supplied by us.
The installation and/or use of such products may have an adverse
effect on the active and/or passive safety.
Machines which are not safe to operate or in traffic must be imme-
diately taken out of service and shall not be used, until these defi-
ciencies have been properly rectified.
Safety installations and switches must neither be removed nor
must they be made ineffective.
On machines with cab the ROPS is an integral part
of the cab.
The frame of the machine must not be warped, bent or cracked in
the area of the ROPS fastening.
BW 191/206 AD-5 / BW 191/206 ADO-5