Husqvarna DC 2-48 Operator's Manual page 16

2. Remove the 6 locking knobs and the cover of the
filter housing.
3. Remove the nut and washer.
4. Remove the lock bar and tilt the filter brackets down.
16
5. Pull out the 4 primary filters and put them carefully in
a plastic bag.
WARNING:
remove the primary filters. The particles
in the primary filters are dangerous to
your health.
6. Discard the plastic bag correctly. Refer to local
regulations.
7. Push 4 new primary filters on the filter brackets in to
the filter housing. Install 1 filter at a time. Make sure
that you do not put the edges of the primary filters on
top of each other.
WARNING:
not installed correctly, dust can go into
the air. The dust particles are dangerous
to your health.
8. Install the lock bar.
9. Install the washer and nut. Make sure that there is
no space between the washer and the nut.
CAUTION:
must be correctly installed on the screw
that holds the lock bar. Dust in the
filter housing can cause damage to the
threads on the screw.
Be careful when you
If the primary filters are
The nut and washer
2121 - 002 - 04.07.2023