Wacom Intuos4 Large User Manual page 61

Clicking is difficult.
Double-clicking is difficult.
The pen selects everything,
will not stop selecting.
The eraser selects everything
or will not stop erasing.
You notice a delay at the
beginning of pen or inking
strokes.
You have to press hard with the
pen when clicking, drawing, or
writing.
The pen tip does not function.
Contents Index
Try using a lighter T
• Use the side switch to double-click. Review the technique in
clicking.
• Be sure you are quickly tapping the tablet twice in the same place on
the tablet's active area.
• Try increasing the T
feel and
• Try using a lighter T
• Set an ExpressKey to D
clicks.
• Windows: Try setting your system to launch programs with a single
click. See clicking.
Open the Wacom Tablet control panel and go to the P
T F slider toward F
IP EEL
T
HRESHOLD
Open the Wacom Tablet control panel and go to the E
Move the E
RASER
increase the C
your tools.
Open the Wacom Tablet control panel and go to the P
Try decreasing the T
and double-click). If that does not work, try dragging the T
C D
LICK ISTANCE
assist.
Open the Wacom Tablet control panel and go to the P
T F slider toward S
IP EEL
S
ENSITIVITY
Be sure you are using the pen that originally came with Intuos4.
Other pens may not function properly on the tablet.
Make sure a tablet status LED brightens when the tip is pressed.
If not, you may have defective hardware. See
Check the control panel's P
assigned to the tip.
Contents Index
F . See adjusting tip feel and
IP EEL
D
IP OUBLE
double-click.
F . See
IP EEL
OUBLE
, or select D
IRM
setting. If this does not help, see
F slider toward F
EEL
T setting. If this does not help, see
LICK HRESHOLD
D C
IP OUBLE LICK
slider to the O position in order to turn off double-click
FF
, or select D
OFT
and C T
LICK HRESHOLD
tab and verify that a C
EN
double-click.
C D . See
LICK ISTANCE
adjusting tip feel and
C and use it to issue double-
LICK
EN
... and increase the C
ETAILS
testing your
RASER
, or select D
IRM ETAILS
EN
D (see adjusting tip feel
ISTANCE
EN
... and decrease the
ETAILS
settings.
testing your
LICK
61
adjusting tip
double-click.
tab. Move the
LICK
tools.
tab.
... and
testing
tab.
D
IP OUBLE
tab. Move the
tools.
function is
61