Sony DHC-MDX10 Operating Instructions Manual page 72

Timer-recording radio programs
(continued)
4
Turn jog dial to select either "MD
REC" (MD recording) or "TAPE
REC" (Tape recording, then press
ENTER/YES.
"ON" appears and the hour digits flash
in the display.
.,..',/;./
",,d_ 7
5 Set the time to start recording.
Turn the jog dial to set the hour, then
press ENTER / YES.
The minute indication starts flashing.
. _'_ _ ,._
Turn the jog dial to set the minute, then
press ENTER [ YES.
The hour indication flashes again.
6 Set the time to stop recording
following the above procedure.
When you record onto MD, select
STEREO or MONO by turning the jog
dial then press ENTER/YES before
setting the end time.
The start time appears, followed by the
stop time, the preset radio station to be
recorded (e.g., "TUNER FM 5"), then the
original display appears.
7 Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press TIMER SELECT and turn the jog dial to
select either "MD REC" or "TAPE REC', then
press ENTER/YES.
To change the setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and turn the jog dial to
select "TIMER OFF", then press ENTER / YES.
Notes
• If the power is on at the preset time, the recording
will not be made.
• Do not operate the system from the time the
power turns on until the playback starts (about 30
seconds).
• Smart Space and Level-Synchro recording do not
work.
72