Before You Start Editing - Sony DHC-MDX10 Operating Instructions Manual

Before you start
editing
You can edit the recorded tracks on an MD.
By using the editing functions, you can create
a new sequence to the recorded MD.
Editing functions
• Name - Labelling MDs
Use this function to label discs and tracks.
You can use upper case, lower case,
numbers and symbols for the titles.
• Erase - Erasing recordings
Use this function to erase a single track, all
the tracks, or a portion within a track.
• Move - Changing the order of tracks
Use this function to change the track
numbering.
• Divide - Adding track numbers
Use this function to add track numbers.
This lets you locate your favourite phrases
quickly.
• Combine - Combining recorded
tracks
By using this function, the blank space
between two tracks is erased and those two
tracks are combined to one track. You can
combine the tracks which are not
numerically consecutive, i.e. the track I and
track 4, etc.
• Undo - Cancelling the last edit
Use this function to cancel the last edit and
restore the contents of the MD to the
condition before the edit.
Before editing
To edit the MD, the MD deck requires the
following conditions:
• The MD is recordable.
• The MD deck is in the Continuous mode.
Before editing, check the conditions by
following the procedure below.
1 Check the tab of the MD to be
edited.
If the MD is record protected, "Cl1" and
"Protected" appear in the display
alternately and the MD cannot be edited.
If the MD is protected against erasure,
slide the tab to close the slot.
|
m
2 "
Press PLAY MODE repeatedly until _,
"PROGRAM" and "SHUFFLE"
disappear.
You can edit the MD only in Continuous
mode. You cannot edit the MD in Shuffle
or Programme mode.
After editing
Press _ on the MDs to remove the
MD or press I /¢3 to turn off the
system power.
"TOC" starts lighting or flashing. The
MD recording is complete only after the
recording information is entered to MD.
Note
The MD editing is complete only after all the editing
information is entered to TOC at which point TOC
stops flashing and goes out. Be careful not to
disconnect the mains lead or move the deck before
this point. Before disconnecting the mains lead, do
the following:
- Remove the MD.
- Press ] / (_ to turn off the system.
43