Leveling The Cutting Unit; Greasing The Cutting Unit - Toro Groundsmaster e3200 Operator's Manual

Figure 3
1. Lift arm
2. Castor arm
5. Torque the bolts to the appropriate specification:
•
If you are using the bolts to install the cutting
unit for the first time:
Torque the bolts to 256 to 313 N∙m (189 to
231 ft-lb).
•
If you have previously used the bolts to
install the cutting unit:
Torque the bolts to 195 to 239 N∙m (144 to
176 ft-lb).
6. Insert the cutting-unit connector to the machine
connector (Figure
Figure 4
1. Machine connector
7. Use the machine-connector latches to secure
the connection (Figure
3. Washer
4. Bolt
4).
2. Cutting-unit connector
5).
1. Latches
g433394
8. Set the height of cut; refer to
Height of Cut (page
3

Leveling the Cutting Unit

No Parts Required
Procedure
Level the cutting unit; refer to
Unit (page 10).
4

Greasing the Cutting Unit

No Parts Required
Procedure
Before operating the cutting unit, it must be greased
to ensure proper lubricating characteristics; refer to
Greasing the Castor-Arm Bushings (page
to properly grease the machine will result in premature
g433399
failure of critical parts.
9
Figure 5
Adjusting the
11).
Leveling the Cutting
17). Failure
g451749