Cutting Unit Safety
•
The cutting unit is only a complete machine when
installed on a traction unit. Read the traction
unit Operator's Manual carefully for complete
instructions on the safe use of the machine.
•
Stop the machine, wait for all moving parts to stop,
remove the key, and turn the battery-disconnect
switch to the O
position before inspecting the
FF
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or missing.
1. Warning—read the Operator's Manual for instructions on
torquing the blade bolt/nut to 75 to 81 N∙m (55 to 60 ft-lb).
116-8283
attachment after striking an object or if there is
an abnormal vibration in the machine. Make all
necessary repairs before resuming operation.
•
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
•
Use only accessories, attachments, and
replacement parts approved by Toro.
decal116-8283
1. Thrown object hazard—keep bystanders away from the
machine.
2. Cutting/dismemberment hazard of hand, mower
blade—stay away from moving parts, keep all guards and
shields in place.
3. Cutting/dismemberment hazard of foot, mower blade—stay
away from moving parts, keep all guards and shields in
place.
4
120-6604
133-8061
decal120-6604
decal133-8061