Greasing The Castor-Arm Bushings; Removing The Cutting Unit From The Traction Unit - Toro Groundsmaster e3200 Operator's Manual

Greasing the Castor-Arm
Bushings
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease.
1. Park the machine on a level surface, lower the
cutting unit, shut off the machine, remove the
key, and turn the battery-disconnect switch to
the O position.
FF
2. Lubricate the castor-arm bushings
Figure 16
Removing the Cutting Unit
from the Traction Unit
1.
2.
(Figure 16).
1. Height-of-cut chain
g011557
3.
4.
17
Park the machine on a level surface with the
cutting unit raised.
Remove the height-of-cut pins
the cutting-unit side plates.
Figure 17
Lower the cutting unit, shut off the machine, and
remove the key.
Remove the bolts and washers that secure the
lift arms to the castor arms
(Figure 17) from
g296784
2. Pin
(Figure 18).