Adjusting The Height Of Cut - Toro Groundsmaster e3200 Operator's Manual

4. Raise the cutting unit to the T
5. Adjust the shims on the front caster forks to
match the desired height of cut.
6. Rotate the blades 180° and measure from the
floor to the rear-facing tip of the blade.
7. Loosen the lower jam nuts on the height-of-cut
chain U-bolt (Figure
1. Jam nuts
2. U-bolt
8. Adjust the nuts (Figure
rear of the cutting unit so that the tips of the rear
blades are 6 to 10 mm (1/4 to 3/8 inch) higher
than the front tips.
9. Tighten the jam nuts.

Adjusting the Height of Cut

The height of cut is adjustable from 25 to 152 mm (1
to 6 inches) in 13 mm (1/2 inch) increments. To adjust
the height of cut:
1. Park the machine on a level surface, raise the
cutting unit to the T
off the machine, remove the key, and turn the
battery-disconnect switch to the O
2. Perform the following procedures:
•
Position the castor wheel axles in the upper
or lower holes of the castor forks; refer to
Positioning the Castor-Wheel Axles (page
11).
•
Add or remove an equal number of spacers
from the castor forks; refer to
Castor-Fork Spacers (page
•
Use the pins in height-of-cut plates to position
the lift-arm chains; refer to
Height-of-Cut Chain (page
RANSPORT
6).
Figure 6
3. Height-of-cut chain
6) to raise or lower the
position, shut
RANSPORT
position.
FF
Positioning the
11).
Positioning the
12).
Positioning the Castor-Wheel
position.
Axles
Position the castor-wheel axles in the same holes in
both castor forks. Refer to
determine the correct holes for the setting.
g296783
1. Tensioning cap
2. Spacers
3. Shims
1. Castor wheel height-of-cut
mounting holes
Note:
If you operate with a 64 mm (2-1/2 inch) height
of cut or higher, set the axle bolt in the lower hole to
prevent grass buildup. If you detect grass buildup
while operating, reverse the machine direction to pull
any clippings away from the wheel/fork area.
Positioning the Castor-Fork
Spacers
1. Remove the tensioning cap from the spindle
shaft
castor arm. Put the 2 shims onto the spindle
11
Figure 7
Figure 7
4. Axle mounting holes
5. Castor wheel
Figure 8
2. Castor fork height-of-cut
spacers
(Figure 7) and slide the spindle out of the
and Figure 8 to
g031661
g296889