Unigas LO35 Manual page 12

ASSEMBLY OF FLEXIBLE LIGHT OIL HOSES
Proceed as follows to connect the flexible light oil hoses to the pump:
Remove the burner cover.
Remove the burner component plate and position it as indicated in Fig. 20a or Fig. 20b on Page 16.
Remove the light oil pump delivery and return line plugs.
Assemble the rubber seal on the flexible light oil hoses and
the power cord as shown in the figure, while also re-assem-
bling the cable-clamp plate (P in Fig. 17).
Reassemble the burner component plate and cover.
12
Fig. 14
Fig. 16
PART I: INSTALLATION MANUAL
Screw the rotating nut of the two flexible hoses on the pump
being careful to avoid inverting the delivery and return lines.
Insert the rubber seal in its seat in the burner volute and fas-
ten it in place using the V screws.
Fig. 15
V
Fig. 17