VTech vt2422 User Manual page 4

Enter Base ID Code
1.
After charging the Handset, remove
it from its Charge Cradle, the screen
will display:
2.
Press NEW , then enter the 15 digit
Base Unit ID code, located on the
underside of the Base Unit.
3.
Press OK . The Handset will display:
PLEASE WAIT!!
4.
Wait approximately 15 seconds.
The Handset will display:
FOUND BASE
If the Handset displays: BASE
BUSY TRY LATER, this indicates
that the system is in use. Wait until
the Base Unit is in the idle (on hook)
mode, and repeat step 2 to 4.
Congratulations! You can now enjoy the
benefits of your multi-Handset system.
Registration
6
1
. Antenna
2
. Message Waiting Indicator
3
. Earpiece
4
. Headset Jack (2.5mm)
5
. Scroll Keys
6
. On (Flash)
7
. Dialing Key (0-9)
8
. Handsfree Speakerphone
The Handset Layout
9
. LCD Display
10
. Select
11
. Off (Clear)
12
. Battery Compartment
13
. Billed Services
14
. Intercom
15. Microphone
7